Honda BF250A - Stopping the Engine

46
OPERATION
The engine will not start or run unless
the emergency stop switch clip is in
the emergency stop switch.
The emergency stop switch clip and
emergency stop switch lanyard
system is a safety device that will
stop the engine if you fall away from
the controls while operating the boat.
Always attach the emergency stop
switch lanyard securely to the
operator or to the operator’s PFD
before starting the engine.
2. Set the control lever in the N
(neutral) position.
The engine will not start if the F
(forward) or R (reverse) gears are
engaged.
3. Turn the ignition switch key to the
ON position; the buzzer will sound
twice.
4. Turn the ignition switch key to the
START position and hold it there
until the engine starts.
When the engine starts, release the
key, allowing it to return to the ON
position.
N (NEUTRAL)
CONTROL
LEVER
IGNITION
SWITCH
KEY
OFF
ON
START
31ZX26040.book Page 46 Friday, July 25, 2014 5:14 PM