53
OPERATION
Under normal conditions, the boat
will perform best when the
antiventilation plate is level with the
water surface.
When cruising into a high wind, trim
the outboard motor down slightly to
level the boat and improve stability.
With a tail wind, trim the outboard
motor up slightly.
Excessive trim/tilt angle during
operation can cause propeller
ventilation, overheating, and water
pump damage.
Side-Mount Type Top-Mount Type
POWER TRIM/TILT SWITCH
Panel-Mount Type
POWER TRIM/TILT SWITCH
(single type)
POWER TRIM/TILT SWITCH
(dual type)
POWER TRIM/TILT SWITCH
(LEFT) (RIGHT)
31ZX26040.book Page 53 Friday, July 25, 2014 5:14 PM
To Next Page
Loading...
