Honda BF250A - Engine Cover and Oil Service

61
SERVICING YOUR OUTBOARD MOTOR
(2) These items should be serviced by your servicing dealer, unless you have the proper tools and are mechanically proficient. Refer to the Honda Shop Manual
for service procedures. See “Honda Publications” on page 115 for ordering information.
(3) For professional commercial use, log hours of operation to determine proper maintenance intervals.
(4) When operating in salt water, turbid or muddy water, the engine should be flushed with clean water after each use.
(5) Upon starting, check for unusual engine sounds and cooling water flowing freely from the check hole.
(7) Check the fuel line for leaks, cracks, or damage. If it is leaking, cracked, or damaged, take it to your servicing dealer for replacement before using your
outboard.
(8) Replace the fuel line if there are signs of leaks, cracks, or damage.
Each use After use
First month
or
20 hrs.
Every
6 months
or
100 hrs.
Every year
or
200 hrs.
Every
2 years
or
400 hrs.
Every
6 years
or
1,200 hrs.
Water separator Check o
Fuel filter Check o o
Replace o
Fuel filter
(High pressure type)
Check o (2)
Replace o (2)
Thermostat and thermostat cover Check o (2)
Fuel line Check o (7)
Replace Every 2 years (If necessary) (2) (8)
Battery and cable connection Check level-tightness o
Bolts and nuts Check-tightness o (2) o (2)
Crankcase breather tube Check o (2)
Cooling water passages Clean o (4) o (4)
Coolant leak Check o
Water pump Check o (2)
Housing, Impeller Check o (2)
Emergency stop switch Check o
Engine oil leak Check o
Each operation part Check o
Engine condition (5) Check o
Power Trim/Tilt Check o (2)
Shift Cable Check-adjust o (2)
REGULAR SERVICE PERIOD (3)
Perform at every indicated month or operating
hour interval, whichever comes first.
ITEM
31ZX26040.book Page 61 Friday, July 25, 2014 5:14 PM