Honeywell 8EP417A User Manual

Accenta/Optima Engineer’s Manual
37
3 = Inhibit Zones
This is a zone which, on setting the panel, allows access to the entry/exit zone. However, if the panel is set and
a time inhibited zone is triggered before an entry/exit timed zone then an alarm will be generated immediately.
LCD Keypad:
NOTE: Pressing the number toggles the zone ON or OFF
While in Engineer program mode, to set up zones as inhibit,
• Press to give a choice of programs or press until
P>Programs is displayed then press .
• Select program 1, 2 or 3.
• The first screen to appear is Program Edit Used Zones.
• Press [3] to enter into Inhibit Zones. The first zone can now
be set as inhibited or uninhibited.
• To edit the other zones press [Number] or to go to a
particular zone.
• Press three times to leave menu.
LED Keypad:
NOTE: Pressing the number toggles the zone ON or OFF
While in Engineer program mode, to set up zones as inhibited,
• Press to give a choice of programs. LED’s 1, 2 and 3 are
flashing.
• Select program [1, 2 or 3]. If program 1 is selected, LED 1 is ON.
• Press [3] to enter into Inhibit Zones. The first zone can now be
set as inhibited or uninhibited.
• To edit the other zones press [Number] to go to a particular zone.
Default settings are shown opposite.
• Press three times to leave menu.
Programs (contd)
[3]
1: Descriptor
Inhibit: YES
P>Select Program
1 2 or 3
P>Program Edit
Used Zones
[Number]
[Number] or
2: Descriptor
Inhibit: NO
P>Programs
[1]
[3]
12
3
4
5
6
7
8
12
3
4
5
6
7
8
[Number]
12
3
4
5
6
7
8
12
3
4
5
6
7
8
12
3
4
5
6
7
8

Honeywell 8EP417A Specifications

General

Brand	Honeywell
Model	8EP417A
Category	Security System
Language	English