Honeywell CIPer 30 - Page 17

CIPer
TM
MODEL 30 CONTROLLER - INSTALLATION AND OPERATIONS GUIDE
17
31-00206 - 02
6. Click Next.
7. The install/upgrade core software from the distribution file should look like the below image. If not,
then go back and make sure the files from the zip folder were copied to the correct location and that
the WEBs N4 4.9.0.198 workbench was restarted.
NOTE
DO NOT click the Upgrade All Out of Date during the Install/Upgrade core modules
step (refer below image).