Honeywell CIU 888 - Page 88

Advanced CIU 888 Settings
Ensite Pro to CIU 888 Migration Manual Part No.: 4417593_Rev09
6 - 2 CIU 888
$*6
During commissioning/configuration of the CIU 888 using Ensite Pro,
perform the following steps to configure the date and time:
1. Click (Set Date & Time) in the Ensite Pro toolbar.
The Set Date & Time window is displayed (see FIGURE 6-3). By
default, the current time and date are displayed.
FIGURE 6-3 Ensite Pro - Set Date & Time window
2. From the drop-down list, select the CIU for which you want to set the
date and time.
3. Enable the New date and time check box if you want to set a new
date and time.
4. Enter the time. The format is: Hours (00...23) - Minutes (00...59) -
Seconds (00...59). Use the arrow buttons to increase or decrease
the hours, minutes or seconds.
5. Select the month and year in the calender. Next, select the day from
the calender. Use the arrow buttons to display the previous or the
next month.
6. Enable the Daylight Saving Time ON check box, if necessary.