6 - 27
Storage Card Screen
The Storage Card screen displays the current capacity and usage statistics of the selected memory
type: IPSM, RAMDISK or Storage Card. Select the memory type from the drop-down list. RAMDISK is
selected by default.
• IPSM (Internal Persistent Storage Manager)
Data or programs stored in the IPSM are not affected when the operating system is upgraded.
Autoinstall programs, for example, are stored in \\IPSM\Honeywell\Autoinstall so that they are
always installed after an operating system upgrade or factory reset. Contact a Honeywell
technical support representative for more information on how to perform a factory reset. For
contact information, see Technical Assistance on page 16-1.
• RAMDISK, is a virtual disk that resides in RAM, volatile memory. The virtual disk provides faster
access speed than the ISPM or other system folders. RAMDISK is volatile and is cleared when
a reset (i.e., soft, hard or factory) is performed or power is lost.
• Storage Card
You can install one memory card in Dolphin terminals (see Installing a SIM Card and/or Memory
Card on page 3-17). If a storage card is installed in the terminal, you can select it in the drop-
down list and see capacity and usage statistics for the card.
Power
Power system settings contains two tabs: Battery and Advanced
Touch > Settings > System > Power
To Next Page
Loading...
