12 - 9
Mounting
Set the base on a dry, stable surface, such as a desktop or workbench near an electrical outlet. Be sure
to provide enough workspace with good lighting for the user to view and operate the Dolphin terminal
while it is in the base.
When choosing a mounting location, bear in mind that the location must allow users' easy access to the
Auxiliary Battery Well and the back panel of the HomeBase where the serial port, USB port, and the
power jack are located.
Installation Hardware
Screw: 3/16 in. dia x 5/8 in. long pan head screw
Washer: 1/2 in. OD x 7/32 in. ID x 3/64 in. thick
Nut: 3/16 in. dia
Desk Mounting
The DIN rail slot (7.5 X 35 mm) may be mounted on the bottom to allow for secure desk attachment of
the unit if desired.
Auxiliary Battery Well
Serial and USB
por
t
location (not in
view)
DIN Rail (7.5 X 35
mm)
Slide the DIN rail slot along the bottom panel.
Then, using the appropriate nuts and bolts, secure the DIN rail to the desk or flat surface.
To Next Page
Loading...
