Honeywell Dolphin 99EX - Back Panel; Power; Connecting Power to the Chargebase

Preliminary
Draft 1/19/11
15 - 3
Back Panel
Power Supply Connector
Power Supply Connector
This connector receives input from the power adapter. Plug the power connector cable from
the power adapter into this connector.
Power
The terminal requires 12 Volts DC input for battery charging; the power adapter on the power cable con-
verts the voltage from the power source to 12 volts DC. Only the Honeywell 12V/8.5A power supply pro-
vided with the Net Base converts the voltage appropriately. The operating temperature range is -10° to
45°C (14° to 113°F).
Honeywell recommends that you leave the ChargeBase connected to its power source at all times, so
that it is always ready to use.
We recommend use of Honeywell peripherals, power cables, and power adapters. Use of any non-Honeywell
!
peripherals, cables, or power adapters may cause damage not covered by the warranty.
Connecting Power to the ChargeBase
A/C Power Cord
LED
Power Adapter
Power Connector Cable
1. Plug the A/C power cord into the power adapter.
2. Plug the power connector cable into the power connector on the back panel of the ChargeBase.
3. Plug the A/C power cord into a standard wall outlet. The LED on the Power Adapter illuminates to
indicate power.
4. All of the Power/Dock LEDs illuminate red to indicate the base has power. Terminal wells with
properly docked Dolphins indicate power with a green LED.