7 - 15
There are two screens: Main and Storage Card.
Main Screen
This screen displays the usage statistics of the on-board,
volatile RAM memory.
Columns:
Storage = RAM
memory
used to store
programs
and
program
data.
Program = RAM memory used to run programs.
Ro
ws:
Total = Displays the current MB of memory allocated for use.
In use =
Displays
the total MB of that
allocated memory
being used.
Free = Displays the total MB of memory available.
Storage Card Screen
This screen displays the current capacity and usage sta-
tistics of the selected memory type: IPSM or Storage
Card.
Select the memory type from the drop-down list. IPSM is
selected by default.
Total storage card memory=
The total MB of memory capacity of IPSM or Storage Card.
In use = The MB currently being used.
Free = The MB that is still available for use.
Note: The IPSM partition is fixed at 128MB and cannot be
increased in size.
IPSM—Short for Internal Persistent Storage Manager, this is the on-board Flash
memory that is non-volatile. This memory is non-volatile, data or programs stored in
IPSM are not affected when power is removed or the operating system is upgraded.
Autoinstall programs, for example, are stored in \\IPSM\Honeywell\Autoinstall so that
they are always installed after a operating system upgrade or factory reset. See Hon-
eywell support for more information on how to perform a factory reset.
Storage Card—You can install one memory card in Dolphin terminals (see Installing
a Memory Card on page 3-10). If a storage card is installed in the terminal, you can
select it in the drop-down list and see capacity and usage statistics for the card.
RIL
The RIL Information screen displays useful statistics for the GSM WAN Voice module (PH8).
To verify whether or not the GSM radio is enabled, check the Dolphin Wireless Manager (see page 8-6).
To Next Page
Loading...
