Galaxy Flex Installer Manual Codes [42, Quick Menu 7]
51
Manager Code
The manager is authorized to modify the manager PIN, which cannot be deleted, and assign
MAX features to the code.
Note: The manager PIN can be reset to the default code (1234) by the engineer and remote
code using the Reset Mgr (Manager) parameter (refer to Reset MGR [51.21]). The
manager code defaults to group choice when groups are enabled. The manager is
able to toggle the group choice option on and off using the
key.
The manager code defaults to accessing the full menu. To access the quick menu, remove
the
assigned to the manager in the Modify Level option.
Programming Codes
Users can modify their own PINs only.
User Codes [42.1]
Details of the first user (User 001) are displayed. The following typical information is
displayed on the keypad.
■
= no pin assigned
= pin assigned
You can scroll to the specific user or enter a user’s number, for example 023 or 069.
When the required code is displayed, press ent to select the modification options; 1=Modify
PIN is displayed first.
Scroll to the required option or type an option number, and then press ent. The options are
described below.
Standard user access
Modify PIN [42.1.User code.1]
PINs identify each user to the panel and permit users to operate the system.
Use this option to assign a PIN to a selected user, or modify an existing PIN. The PIN must
be a four, five or six digit number, and unique to the system.
Note: PIN size is dependent on the Min Pin Size [51.66] parameter.
001 User ■ m
L3 A 1234
user type
user number
user name
group mode
max card/tag/fob assigned
To Next Page
Loading...
Need help?
General
