21
Vigilon Plus fire alarm system
To carry out a display test
You can test the message display and the indicators on the
control panel.
a. Press the MENU ON/OFF button and then the F4 button to
select [Test/Eng].
b. Press the F1 button to select [Disp Test]. Check that the
following things happen: The display clears, the indicators
illuminate, the buzzer sounds two distinct tones and then
the display shows the system status message. The display
test lasts for about 4 seconds.
How to change your PIN code
The following terms: Password, PIN, Usercode and Access
code mean the same and are used interchangeably.
A Customer user PIN code (password) is normally set up by
the servicing organisation during commissioning of the re
alarm system. The customer PIN code is set up for the end
user. The person responsible for the re alarm system should
be aware of this PIN code. For security the PIN should be
changed on a regular basis.
A previously created PIN can be changed:
a. Press the MENU ON/OFF button.
b. Press the F4 button to select [Test/Eng].
c. Press the F4 button to select [UserCode]. Use the keypad
to input your existing access code and then press the Enter
button.
d. Press the F1 button to select [NewPass]. At the ashing
cursor using the keypad input the PIN code and press the
Enter button. Notice ‘New access code set up’ appears on
the display.
Any changes made to the PIN code must
be backed-up to the panel memory. If this is
not done then the previous PIN is restored
on resetting the panel, see section on
‘How to save changes to memory’. It is not
necessary to backup the password at a
repeat panel.
www.acornfiresecurity.com
www.acornfiresecurity.com
To Next Page
Loading...
