Need help?Do you have a question about the Honeywell MA Series and is the answer not in the manual?
General| Brand | Honeywell |
|---|---|
| Model | MA Series |
| Category | Fire Alarms |
| Language | English |
Defines project engineers, service engineers, and installation personnel.
Explains meanings of Warning, Note, and Standards/Guidelines symbols.
Lists installation and commissioning manuals for MAx panels and repeaters.
Defines terms like LINE, POINTS, ZONES, and GROUPS in the MAx system.
Describes the function of buttons like EVACUATION, END DELAY, SILENCE, RESET.
Explains the use of virtual buttons like PGRM, UTIL, DISABL, TEST.
Describes the function of arrow, ENTER, and ESCAPE buttons for data entry.
Details LEDs for ALARM, PREALARM, SILENCE, DELAY, EVACUATION, TEST, POWER.
Details LEDs for FAULTS, SYSTEM, POWER SUPPLY, EARTH FAULT, DISABLEMENTS.
Lists functions, their EN 54 levels, and factory default passwords.
Describes keyboard usage, text entry, and password input.
Describes the default screen and navigation through zones.
Explains icons for OK, FIRE, FAULT, TEST, and DISABLEMENT states.
Shows pre-alarm events and how to navigate through zones and devices.
Details pre-alarm events, time, date, and programmed text.
Displays alarm events and allows navigation through zones and devices.
Provides details on alarm events, time, date, and device status.
Shows zone fault events and allows navigation through faulty zones.
Details fault events, text, and device fault type.
Accesses system configuration and allows language selection.
Allows setting the control unit's date and time.
Configures LED blinking for points, useful in specific environments.
Configures drift warning threshold and detector pre-alarm settings.
Enables or disables logging of events for NONA type modules.
Configures parameters for Invalid Reply, Type-ID, Open-C, Low Chamb, Maint.
Sets sounder activation, volume, and evacuation control parameters.
Provides access to print History Log, Alarms, Prealarms, Zone Faults, and more.
Allows viewing and filtering events by date, alarms, faults, etc.
Details log capacity, event saving, and clearing the history log.
Option to disable saving new events to the history log.
Procedure to save the history log file onto a USB memory stick.
Examines detector status and displays analog values as a percentage.
Views module status and allows modifying output status (ON/OFF).
Displays the status of configured groups.
Displays the status of configured zones.
Lists active input modules connected to the control unit lines.
Lists active output modules connected to the control unit lines.
Shows counts of disabled detectors, modules, zones, and system.
Allows changing enabled/disabled status with level 2 password.
Displays the firmware version of the control unit CPU, LIB card, and LCD.
Describes uploading new firmware from a USB memory stick.
Steps to disable detectors, preventing alarms and fault signalling.
Steps to disable modules, preventing alarms and fault signalling.
Steps to disable zones, preventing alarms and fault signalling from points.
Configures whether sounder is excluded from immediate activation.
Allows exclusion of siren output and associated modules from immediate alarm.
Initiates a walk-test for a selected zone, enabling CBEs and outputs.
Selects outputs (NONE, SOUNDER, MODULE) to activate during zone tests.
Performs lamp-test, display test, and buzzer test functions.
To Next Page