Honeywell Granit XP 199 i Series - Page 267

Granit XP User Guide 249
Primary/Alternate Data Formats Primary Data Format ALTFNM0 139
Data Format 1 ALTFNM1 139
Data Format 2 ALTFNM2 139
Data Format 3 ALTFNM3 139
Single Scan Data Format Change Single Scan-Primary
Data Format
VSAF_0 139
Single Scan-Data Format 1 VSAF_1 140
Single Scan-Data Format 2 VSAF_2 140
Single Scan-Data Format 3 VSAF_3 140
Symbologies
All Symbologies All Symbologies Off ALLENA0 142
Codabar Default All Codabar
Settings
CBRDFT 142
Off CBRENA0 142
*On CBRENA1 142
Codabar Start/Stop Char. *Don’t Transmit CBRSSX0 143
Transmit CBRSSX1 143
Codabar Check Char. *No Check Char. CBRCK20 143
Validate, But Don’t Transmit CBRCK21 143
Validate, and Transmit CBRCK22 143
Codabar Concatenation *Off CBRCCT0 144
On CBRCCT1 144
Require CBRCCT2 144
Codabar Message Length Minimum (2 - 60) *4 CBRMIN## 144
Maximum (2 - 60) *60 CBRMAX## 144
Code 39 Default All Code 39
Settings
C39DFT 145
Off C39ENA0 145
*On C39ENA1 145
Code 39 Start/Stop Char. *Don’t Transmit C39SSX0 145
Transmit C39SSX1 145
Code 39 Check Char. *No Check Char. C39CK20 145
Validate, But Don’t
Transmit
C39CK21 145
Validate,
and Transmit
C39CK22 145
Code 39 Message Length Minimum (0 - 48) *0 C39MIN## 146
Maximum (0 - 48) *48 C39MAX## 146
Selection
Setting
* Indicates default
Serial Command
# Indicates a numeric
entry
Page