88 Granit XP User Guide
Presentation Mode
Presentation Mode uses ambient light and scanner illumination to detect bar-
codes. When in Presentation Mode, the LEDs remain dim until a barcode is pre-
sented to the scanner, then the aimer turns on and the LEDs turn up to read the
code. If the light level in the room is not high enough, Presentation Mode may not
work properly
Note: If you are using a cordless charge base in Presentation Mode, the battery will not
charge unless the power supply is plugged into the base’s auxiliary power port.
Scan the following barcode to program your scanner for Presentation Mode.
Triggered Presentation Mode
This mode uses light to detect the presence of an object. Default = Ambient and
Scanner Light.
Presentation LED Behavior after Decode
When a scanner is in presentation mode, the LED aimer dims 30 seconds after a
barcode is decoded. If you wish to dim the LED aimer immediately after a barcode
is decoded, scan the LEDs Off barcode, below. Default = LEDs On.
*Ambient and Scanner Light
To Next Page
Loading...
