Granit XP User Guide 105
5. End Output Sequence Editor
Use FF to terminate this string or to begin another output sequence. If you are
using barcodes, scan F F. Scan Save to save your entries.
Other Programming Selections
If you are creating an output sequence using barcodes, scan Discard (page 292) to
exit without saving any output sequence changes.
Output Sequence Editor Commands
SEQBLK Sequence editor start command.
SEQPRE Add prefix to complete output sequences.
SEQSUF Add suffix to complete output sequences.
SEQSEP Add separators to complete output sequences.
SEQTTS1 Transmit partial sequence.
SEQSAT Define satisfactory subsets of full output sequence.
SEQTIM Timeout for sequence members when using SEQSAT.
SEQIPR Add prefix to partial output sequences.
SEQISU Add suffix to partial output sequences.
SEQISE Add separators to partial output sequences.
TRGSTO Timeout for partial output sequences.
FF Termination string.
Examples outlining how to use these commands are shown below.
Output Sequence Example 1 - Three Symbologies
In this example, you are scanning PDF417, Code 128, and Code 39 barcodes, but
you want the scanner to output Code 39 first, Code 128 second, and PDF417 third.
Set up the sequence editor with the following command line:
SEQBLK sequence editor start command
To Next Page
Loading...
