Granit XP User Guide 275
Replace an Interface Cable
1. Turn off the power to the host system.
2. Disconnect the scanner’s cable from the terminal or computer.
3. Locate the small screw at the bottom of the locking plate.
4. Loosen the screw.
5. Loosen the locking plate and slide it over the base of the cable connector to
remove the cable from the device.
6. Remove the O-ring from the end of the cable connection.
7. See Connect a Corded Device, to connect the new cord to the scanner.
Replace Cables and Batteries in Cordless Systems
Replace an Interface Cable in a Base
1. Turn the power to the host system OFF.
2. Disconnect the base’s cable from the terminal or computer.
3. Turn the base upside down.
4. Pull the connector out while maintaining pressure on the connector release
clip.
5. Replace with the new cable. Insert the connector into the opening and press
firmly. The connector is keyed to go in only one way, and will click into place.
Change a Scanner Battery
1. Rotate metal twist at bottom of battery door counterclockwise.
2. Remove battery.
3. Insert replacement battery.
4. Replace end cap and screw together.
Troubleshoot a Corded Scanner
The scanner automatically performs self-tests whenever you turn it on. If your
scanner is not functioning properly, review the following Troubleshooting Guide to
try to isolate the problem.
Is the power on? Is the aimer on?
If the aimer isn’t illuminated, check that:
To Next Page
Loading...
