Granit XP User Guide 225
UTILITIES
To Add a Test Code I.D. Prefix to All Symbologies
This selection allows you to turn on transmission of a Code I.D. before the decoded
symbology. (See the Symbology Charts, beginning on page 279 for the single char-
acter code that identifies each symbology.) This action first clears all current pre-
fixes, then programs a Code I.D. prefix for all symbologies. This is a temporary
setting that will be removed when the unit is power cycled.
Show Software Revision
Scan the barcode below to output the current software revision, unit serial number,
and other product information for both the scanner and base.
Test Menu
When you scan the Test Menu On code, then scan a programming code in this
manual, the scanner displays the content of a programming code. The program-
ming function will still occur, but in addition, the content of that programming
code is output to the terminal.
Note: This feature should not be used during normal scanner operation.
Add Code I.D. Prefix to
All Symbologies (Temporary)
To Next Page
Loading...
