Honeywell HON 673 - Page 18

Description
HON 380 gas pressure regulator with HON 673/674 controller 18
Gas pressure regulator with regulator unit
RE1 RE2 RE0
Size
G
mm
(in.)
ØH
mm
(in.)
J
mm
(in.)
G
mm
(in.)
ØH
mm
(in.)
J
mm
(in.)
G
mm
(in.)
ØH
mm
(in.)
J
mm
(in.)
DN 80 (3″)
-
640
(25.20)
200
(7.87)
620
(24.41)
200
(7.87)
DN 100 (4″)
630
(24.80)
205
(8.07)
610
(24.02)
205
(8.07)
HON 380 weights
Gas pressure regulator with regulator unit
RE1 RE2 RE0
with SAV without SAV with SAV without SAV with SAV without SAV
Size kg (lb) kg (lb) kg (lb) kg (lb) kg (lb) kg (lb)
DN 25 (1″)
18 (40) 16 (35) 34 (75) 32 (71)
DN 50 (2″)
24 (53) 22 (49) 35 (77) 33 (73) 41 (90) 38 (84)
DN 80 (3″)
73 (161) 65 (143) 79 (174) 71 (157)
DN 100 (4″)
89 (196) 80 (176) 95 (209) 85 (187)
Connections of the lines
Controller SAV
Measuring line Vent line Measuring and breather lines
Connection for
RE1
Pipe 12 x 1.5
(pipe 12 x 1.5 on the device)
Pipe 12 x 1.5
(thread G 1/2)
RE2
Pipe 16 x 2
(pipe 16 x 2 on the device)
Pipe 12 x 1.5
(thread G 1/2)
Pipe 12 x 1.5
(thread G 3/8)
RE0
Pipe 16 x 2
(thread G 1/2)
Pipe 12 x 1.5
(thread G 3/8)
Criterion Value
Nominal diameter
DN 25 (1″), DN 50 (2″), DN 80 (3″), DN 100
(4
″
)
Maximum operating pressure
20 bar (285 psi)
Criterion Value
Nominal diameter
DN 25 (1″), DN 50 (2″), DN 80 (3″), DN 100
(4
″
)
Maximum operating pressure
16 bar (232 psi)
The device’s mechanical components do not contain any potential sources of ig-
nition, and accordingly do not fall under the scope of ATEX 95 (94/9/EC). The
electrical components used on the device meet all applicable ATEX requirements.
Operating pressure,
Class 150
Operating pressure,
PN 16
ATEX specifications