Honeywell HON 673 - Adjusting Device Settings; Adjusting Regulator Unit Setpoint

Adjusting the settings of the device
HON 380 gas pressure regulator with HON 673/674 controller 33
6 Adjusting the settings of the device
Topic Page
Adjusting the regulator unit setpoint 33
Adjusting the throttle valve on the measuring line of the regulator unit 36
6.1 Adjusting the regulator unit setpoint
Make sure that the following requirements are met:
 Apply the inlet pressure slowly because the device is open when in the pres-
sureless state.
 The inlet and outlet shut-off devices for the gas regulating line section with
the gas pressure regulator are closed.
 The pressure in the outlet chamber downstream of the gas pressure regula-
tor is lower than the setpoint for outlet pressure p
d
.
 The shut-off devices for the blowdown lines are closed.
 The inlet pressure is present upstream of the inlet shut-off device.
Pilot spring of the regulator unit
Specific setpoint
range
W
ds
[mbar]
Compression spring
RE0 RE1 RE2
Part no.
Wire di-
ameter
[mm]
Part no.
Wire di-
ameter
[mm]
Part no.
Wire di-
ameter
[mm]
Color
20 - 30 10007241 3.6 15056070 5 Signal blue
25 - 50 10003629 4 10009068 6.3 grey
45 - 75 15055022 4.5 15056072 7 Gentian blue
70 - 100 10003630 4.5 10009069 7 Yellow
90 - 160 15055023 5.3 15056073 8 Fire red
150 - 200 10003631 5.3 10009070 8 brown
190 - 260 15055024 6.3 15056074 9 Nut brown
250 - 300 10003632 6.3 15056075 9 Light red
290 - 360 15055025 7 15056076 10
Rapeseed yel-
low
350 - 400 10003633 7 10009072 10 Dark red
390 - 500 15055026 7.5 10009073 11 light blue
490 - 560 15055027 8.5 15056077 11
Rapeseed yel-
low
550 - 660 15055028 9 15056078 12 Cream white
650 - 760 15055029 9.5 15056079 12 Gentian blue
750 - 800 10012564 9.5 10009164 13 Emerald green
790 - 900 15055030 10 15056081 13 Fire red
890 - 1000 15055031 10 10009165 14 black
Contents
Requirements