Honeywell HW-AV-LTE-M - Wiring for Dry Contact Relay Outputs

01.
Connect the panel to the communicator as specified in Wiring for Dialer Capture.
02.
Power up the system as specified in Powering On.

Figure 5-1: Wiring for Dialer Capture
Panel Terminal Panel Connector
Pathway
Connection
AUX + +
GND - -
PRIMARY DIALER

RING RING
TIP TIP
BACKUP DIALER

RING2 RING2
TIP2
TIP2
5.7.1 WIRING FOR DRY CONTACT RELAY OUTPUTS
The communicator can be wired to monitor dry contact relay outputs. This wiring is done without connecting to a dialer interface.
CAUTION: WIRING RESTRICTIONS
ALL WIRING MUST BE WITHIN A CONDUIT.
DO NOT USE RESETTABLE POWER TERMINALS.
Wiring for Dry Contact Relay Outputs
Honeywell Connected Life Safety Services | Honeywell Connected Life Safety Services
Installation and Operation Manual | REV. B
17
Wednesday, February 28, 2024