03.
Ensure that the Green LED on the communicator is continuously ON indicating successful connections.
NOTE: Refer to Troubleshooting if there is an issue to resolve.
ACTIVATING CENTRAL STATION COMMUNICATION
CAUTION: VERIFY ALL CONNECTIONS
BEFORE ACTIVATING THE CENTRAL STATION COMMUNICATION, CHECK ALL CONNECTIONS.
When the CLSS Pathway receives its first event from its panel, it registers itself with CLSS Site Manager and the central monitoring
station, and then becomes active.
The panel event appearing on CLSS Site Manager confirms that the communicator is activated. Create a test event on the panel to
perform this one-time activation.
NOTE: Connection results such as the signal strength can be checked in the CLSS App.
5.9 DUAL-PATH COMMUNICATIONS
01.
Connect the LAN port of the communicator to the customer’s network.
02.
Observe that the Yellow LED for network connectivity is flashing to indicate a live Ethernet connection.
5.10 VERIFYING THE COMMUNICATIONS
The RJ45 connector LEDs should have the following states:
RJ45
Connector
LED State Indication
Yellow LED Constantly
ON
Connected with good signal.
Green LED Blinking Cable connection and communication
with the router are good.
NOTE: Refer to Troubleshooting if there is an issue to resolve.
5.11 CELLULAR SIGNAL STRENGTH
Once the CLSS Pathway is activated, you can check the signal strength shown on the activation screen in the CLSS App.
NOTE: The signal bar shown is in the RSSI (Received Signal Strength Indicator) rating format. The signal bar is not in the
dBm rating.
Honeywell Connected Life Safety Services | Honeywell Connected Life Safety Services
Installation and Operation Manual | REV. B
19
Wednesday, February 28, 2024
To Next Page
Loading...
