INTELLIGUARD 9000
74-3046
16
The Polling Table has the following buttons to edit information:
OK Accepts any changes made to the Polling Table.
Delete Removes a device from a row, but does not remove the row.
Insert Creates a new row for additional devices. The number of rows
increases by one.
Remove Removes a row and any device in that row. The number or rows
reduces by one.
Messages Displays the Messages panel.
2. Click the arrow to the right of the Device field until your choice appears.
3. Double click the device name choice in the pull-down menu.
4. Press Tab to go to the Addr field.
5. Enter the device address.
6. Press Tab to go to the Com field.
7. Enter the Com number to which the device is connected.
8. Press Tab to go to the Serial # field.
NOTE: Locate the serial number on a label attached to the device.
9. Type the serial number into the field if the device has a serial number.
10. Click the arrow to the right of the Location field until the desired location choice
appears.
11. Double click the location choice in the pop-up menu.
12. Press Tab to go to Area Msk field.
13. Enter the area numbers where you want to assign the CC-2 or KID.
14. Repeat steps 2 through 13 for each device connected to the I9000.
15. Click OK to accept the changes.
16. Click File to display the File pull-down menu.
17. Click Save to save the changes to the Polling Table.
To Next Page
Loading...
