Honeywell INTELLIGUARD 9000 - General Programming Procedure

INTELLIGUARD 9000
74-3046
6
MODE
GENERAL PROGRAMMING PROCEDURE
Any programming requires the I9000 to be in RPROG mode and the baud rate to
match the PRO9000 Software.
1. Complete the worksheets provided in the Appendix of this manual using the
examples as a guide.
2. At the CC-2, select to display the Mode menu.
3. Enter the technician ID (00) and code (9999).
4. Press 5 to select the Configuration menu.
5. Press to enter the Configuration menu.
6. Press 5 again to select SYSTEM.
7. Press to enter system programming.
8. Press to accept.
NOTE: 0=SMP 1= RPROG
9. Press the to select Baud 0 for the baud rate.
10. Press to enter the program.
11. Press 5 to enter baud rate = 2400.
12. Press until the display shows the time and date.
13. Start PRO9000.
14. Create a new file.
15. Save the new file.
16. Enter the information from the worksheets.
17. Save the information.
18. Connect the PC to the I9000 CU.
19. Download the information from the PC to the CU.