Honeywell INTELLIGUARD 9000 - Viewing; View Arm Status

INTELLIGUARD 9000
21
74-3046
IMPORTANT
The Account Number field is inactive in I9000 systems linked to XSM. The
I9000 address must be set in the System Configuration menu located on
the CC-2.
13. Set Enabled on/off.
a. Click the field for the desired setting [X]=on, [N]=off.
b. Press tab to go to the next field.
14. Set Force Arm on/off.
a. Click the field for the desired setting [X]=on, [N]=off.
b. Press tab to go to the next field.
15. Set Clos. Alrt on/off.
a. Click the field for the desired setting [X]=on, [N]=off.
b. Press tab to go to the next field.
16. Set Auto Rearm on/off.
a. Click the field for the desired setting [X]=on, [N]=off.
b. Press tab to go to the next field.
17. Set Schedule on/off.
a. Click the field for the desired setting [X]=on, [N]=off.
b. Press tab to go to the next field.
18. Set Transm O/C on/off.
a. Click the field for the desired setting [X]=on, [N]=off.
b. Press tab to go to the next field.
19. Set Disp 24 Hr. on/off.
a. Click the field for the desired setting [X]=on, [N]=off.
b. Press tab to go to the next field.
20. Repeat steps 1 through 19 for each area.
21. Click OK to accept the Area Configuration settings.
22. Click File to display the File pull-down menu.
23. Click Save to save the settings.