Honeywell LYNX Touch L5210 Series Guide

Home Automation
Rules
General Information
Up to 40 rules can be programmed. Rules 1 through 20 are used for Triggers, Z-Wave Scenes and Follow-Me
Messages. Rules 21 through 40 are used for Z-Wave Scenes and for E-mail notification but are only accessible
through TotalConnect Service. Check with your Installer to see which options are available to you.
The following options are programmed in this section:
Programming Field
Action
Rule 1 - 20:
Select Rule 1 -20
Note:
Rules 21-40 are only accessible through TotalConnect Service.
Name:
Name the device
Type:
Select the output type
Action:
Select the action required for the device
Start Zone Type OR Zone Type Fault:
Select Zone Type to start event*
Stop Zone Type OR Zone Type Restore:
Select Zone Type to stop event*
Start System Operation OR
System Operation 1:
Select System Operation to start event*
Stop System Operation OR
System Operation 1
Select System Operation to stop event*
Zone Number Operation:
Select Zone Number to trigger event upon fault, trouble or alarm as selected.
* The displayed field is dependent upon the Type selection.
Programming Rules
1. With the system in the disarmed state, select the “Automation”
icon from the Home Screen. The system displays the first
page of the Automation screen. Select the “
” icon to
advance to the second page of the Automation screen.
2.
Select the “Rules” button. The system displays the Rules
screen.
3. Select a “Rules” key followed by the Edit button.
Note: Rules 21-40 are only accessible through TotalConnect
Service.
- 14 -

Honeywell LYNX Touch L5210 Series Specifications

General

Brand	Honeywell
Model	LYNX Touch L5210 Series
Category	Security System
Language	English