• For information on configuring the MS7580 for USB Serial Emulation
Mode or IBM OEM, refer to the USB section of the MetroSelect
Single-Line Configuration Guide (PN 00-02544).
• Plugging the imager into a port on the host device does not guarantee
that scanned information will be communicated properly to the host
device. The imager is shipped from the factory configured with default
settings. Please refer to the MetroSelect Single-Line Configuration
Guide (PN
00-02544) or MetroSet2’s help files for instructions on
changing the imager’s configuration. In addition, please check that the
imager and host system are using the same communication protocol.
To Next Page
Loading...
