Labels
Each MS7580 has a label located near the top of the output window. This label
provides the imager’s model number, date of manufacture, serial number, CE
and caution information. Additional information has been molded into the
underside of the imager's case. The following figure gives an example of the
label and the molded text with their locations identified.
Figure 2. Label and Molded Text Samples
For North America:
CAUTION: To maintain compliance with applicable standards, all circuits
connected to the scanner must meet the requirements of a NEC Class 2
power source or Limited Power Source as defined in UL 60950-1 Clause 2.5.
For Other Countries:
CAUTION: To maintain compliance with applicable standards, all circuits
connected to the scanner must meet the requirements of a Limited Power
Source as defined in IEC 60950-1 Clause 2.5.
Maintenance
Smudges and dirt on the imager's window can interfere with the imager's
performance. If the window requires cleaning, use only a mild glass cleaner
containing no ammonia. When cleaning the window, spray the cleaner onto a lint
free, non-abrasive cleaning cloth and then gently wipe the window clean.
If the imager's case requires cleaning, use a mild cleaning agent that does not
contain strong oxidizing chemicals. Strong cleaning agents may discolor or
damage the imager's exterior.
To Next Page
Loading...
