Honeywell MSR PolyGard 2 MGC2-K - Alarm Status; Relay Status

User Manual - PolyGard
®
2
Multi-Gas-Controller MGC2-K Honeywell
Page 13
PolyGard
®
is a registered trademark of MSR GAMGC2-K_E_0320
Phone 0049(0)8531/9004-0 Fax: 0049(0)8531/9004-54 Specification subject to change without notice
MSR-Electronic GmbH, Bgm.-Schoenbauer-Str. 13, D 94060 Pocking www:msr-electronic.de Made in Germany
AP 1
’’A1
AP 1
Reset?
Check if no
Gas present?
8.2 Alarm Status
Display of the currently pending alarms in plain text in the order of their arrival. Only those measuring points
are displayed, where at least one alarm is active.
Alarms in latching mode and the overrange message can be acknowledged in this menu (only possible if the
alarm isn’t active any more).
Alarm 1 and Alarm 2 are evaluated both by the sensor (alarm bit transmitted by communication) and by the
locally set thresholds.
Symbol
Description
Function
AP 1
Measuring Point No.
Analog measuring point 1 = 1 - 3, where an alarm is pending
DP 4
Measuring Point No.
Digital measuring point 4 = 4 - 11, where an alarm is pending
‘A1
‘‘A1
Alarm status
‘A1 = Alarm 1 active
‘‘A1 = Alarm 1 in latching mode, can be acknowledged
8.3 Relay Status
Reading of the current status of alarm relays.
The actual relay status is displayed, depending on the relay mode (energized <> de-energized).
Selection of the alarm relay 1 – 5
Selection of the next alarm relay
Symbol
Description
Function
1
Alarm Relay
Alarm relay = 1 - 5
OFF
Relay Status
Deenergized
ON
Relay Status
Energized
Alarm Status
Relay
Status
Relay 1
Status OFF