User Manual - PolyGard
®
2
Multi-Gas-Controller MGC2-K Honeywell
PolyGard
®
is a registered trademark of MSR GAMGC2-K_E_0320
Phone 0049(0)8531/9004-0 Fax: 0049(0)8531/9004-54 Specification subject to change without notice
MSR-Electronic GmbH, Bgm.-Schoenbauer-Str. 13, D 94060 Pocking www:msr-electronic.de Made in Germany
8.7.7 MP Fault Assigned to Alarm
In this menu you can define, which alarms should be activated by a fault at the measuring point. If the fault is
cleared, the alarm is automatically reset.
Indication of the alarms 1 to 4; you can define with 1 for each
alarm that the alarm should be activated in case of MP fault.
Assignment of
MP fault to
alarm
0 = Alarm isn’t activated in case of MP fault.
1 = Alarm is activated in case of MP fault.
8.7.8 Alarm Assigned to Alarm Relay
Each of the four alarms can be assigned to any alarm relay 1 – 5 registered in the menu Relay Parameters by
entering the relay address right under the alarm. One alarm relay can be assigned to multiple alarms. Unused
alarms aren’t assigned.
The fault relay can also be used for alarm message (address 3). The relay has to be registered in the menu
Relay Parameters. The fault message function, however, remains unaffected.
Presentation of the alarms 1 to 4; you can assign an alarm relay to
each alarm by setting a relay address.
Assignment of
alarm relay
A1 = X
A2 = X
A3 = X
A4 = X
X = Assignment of an alarm relay (relay address) to an alarm
8.7.9 MP Assigned to Analog Output
The measuring signal can be assigned to an analog output by entering the address of the analog output
instead of x. The analog output is configured in the menu System Parameters, AO Function.
X = Assignment of an analog output by entering the AO address
Alarm - 1234
Fault - 0100
To Next Page
Loading...
