User Manual - PolyGard
®
2
Multi-Gas-Controller MGC2-K Honeywell
PolyGard
®
is a registered trademark of MSR GAMGC2-K_E_0320
Phone 0049(0)8531/9004-0 Fax: 0049(0)8531/9004-54 Specification subject to change without notice
MSR-Electronic GmbH, Bgm.-Schoenbauer-Str. 13, D 94060 Pocking www:msr-electronic.de Made in Germany
12 Technical Data MGC2
24 V DC ± 20 %, reverse-polarity protected
24 V AC ± 15 %
Power consumption (24 V DC)
- Control Board
- per sensor (analog)
- horn / warning light
Max. 60 mA (1.5 VA), without sensor
Max. 85 mA (2.1 VA)
Max. 40 mA (1.0 VA)
240 V AC, 5 A, potential-free, change-over contact (SPDT)
24 V DC / 0.1 A (switching to plus) (only at 24 V DC power supply)
4 – 20 mA overload and short-circuit proof, input resistance 200
Proportional, overload and short-circuit proof, load 500 Ohm
4 - 20 mA = measuring range
3.0 < 4 mA = underrange
> 20 - 21.2 mA = overrange
2.0 mA = fault (not preset)
-25 °C to +50 °C (-13 °F to +122 °F)
15 - 95 % RH not-condensing
+5 °C to +40 °C (+41 °F to +104 °F)
Dimension housing (W x H x D)
Type C
130 x 130 x 75 mm (5.12 x 5.12 x 2.95 in.)
Protection class (delivery status*)
Knockouts for cable and sensor entry
Wire connection:
Digital input, analog output
Power supply, relays
Screw-type terminal min. 0.25 mm2, max. 1.3 mm2 (24 to 16 AWG)
Screw-type terminal min. 0.25 mm2, max. 2.5 mm2 (24 to 10 AWG)
EMC directives 2014/30/EU
Low voltage directive 2014/35/EU
CE
EN 61010-1:2010
*If there are changes on the housing it has to be re-evaluated
Two lines, 16 characters each, background highlighted in two
colours
Menu driven via six pushbuttons