Honeywell NOTIFIER ID2000 Series - Operator Actions at Panel; 4.1 Introduction

ID2000 Series Operating Manual
Operator Actions at Panel
7 997-434-000-4, Issue 4
May 2010
4 Operator Actions at Panel
4.1 Introduction
The panel controls and LCD display allow the following
actions to be carried out:
a. Mute the panel buzzer.
b. Accept a fire or fault condition.
c. Evacuate (and override delay to outputs, if delay is
active).
d. Silence and re-start the alarms.
e. Reset the panel.
f. Test the lamps and control the LCD display contrast.
g. Carry out system tests.
h. Disable and enable devices, zones or all outputs.
i. Display, log and print data.
j. Set the time of day clock.
k. Select Day or Night Mode for remote fire outputs.
l. Set the language displayed on the LCD.
All of these actions are security-controlled by means of
a user interface door (if fitted) or a passcode (see
Section 4.1.2).