ID2000 Series Operating Manual
Operator Actions at Panel
35 997-434-000-4, Issue 4
May 2010
7 If you press just in response to the above question,
one of the options shown below is displayed (which
one depends upon whether the panel is a network
master or not). If you select 1 for ‘YES’ then only
disabled devices are printed.
Note: For option 1 only, if the panel is the Master Panel
on a Network system, any disabled devices
connected to the Slave panels are also printed (this
is the only case in which a list of devices at another
panel can be obtained). The printout will list, in
addition to configuration details about each device
and its current reading, indications of any device
that is disabled and any device that is MISSING
(i.e. registering a NO-REPLY fault).
To abort the printout:
Press
(on the VDU: by pressing any key).
Note: The printout will also be aborted if any new alarm
occurs in the meantime.
Print only DISABLED devices?
(0=NO, 1=YES):
Print only DISABLED devices (ALL stns)?
(0=NO, 1=YES):
To Next Page
Loading...
