Honeywell Notifier ID60 Series User Manual

ID50 Series Panel - Operating Manual
Automatic Alarms - What to do
10997-264-000-10, Issue 10
January 2010
2 If a service contact number has been entered during
panel commissioning, the LCD alternates between the
fault message(s) and the following:
Note: Press the MUTE BUZZER pushbutton to silence
the panel’s internal buzzer.
3 When the cause of the fault has been cleared, press
the RESET pushbutton.
3.3.1 Power Fail
1 The loss of a power supply causes the panel to enter
a Power Fail condition. The POWER SUPPLY FAULT
and general FAULT LEDs illuminate and the internal
buzzer operates. The LCD displays:
a. Fault condition.
b. Fault number currently displayed.
c. Total number of faults logged.
d. Time fault was logged.
e. A text message describing the fault.
A battery fault is shown on the LCD as follows:
2 If a service contact number has been configured, the
LCD alternates between the power fault message and
the service contact number.
Note: Press the MUTE BUZZER pushbutton to silence
the panel’s internal buzzer.
3 When the cause of the fault has been cleared, press
the RESET pushbutton.
If both the AC and
Battery power fail, the
indicators and LCD are
non-operational.
FAULT 01 / 02 14:55
NO MAINS SUPPLY
FAULT 01 / 03 14:55
For Service Contact ***** ******
ABCD
E
FAULT 01 / 02 14:55
BATTERIES MISSING
ABCD
E
Status: NORMAL
Sat 01/12/2001 00:00:00
Status: NORMAL
Sat 01/12/2001 00:00:00
DISABLEMENT FAULT
TEST
POWER SUPPLY FAULT
EARTH FAULT
POWER
PLANT ALARM
FIRE OUTPUT ACTIVE
DELAYS ACTIVE
FIRE OUTPUT: FAULT / DISABLED
FIRE CONTROL O/P: FAULT / DISABLED
PRE- ALARM
SYSTEM FAULT
SOUNDER: FAULT / DISABLED

Honeywell Notifier ID60 Series Specifications

General

Brand	Honeywell
Model	Notifier ID60 Series
Category	Fire Alarms
Language	English