Honeywell oneWireless XYR 6000 - Approved Antenna Types;Gains; Antenna Details; Table 6-1 Approved Antenna Types;Gains

6. Approved Antenna Types/Gains
6.1. Antenna Details
16 OneWireless XYR 6000 Transmitter Professional Installation Guide Revision 3
September 2012
6. Approved Antenna Types/Gains
6.1 Antenna Details
Table 6-1 Approved Antenna Types/Gains
Antenna
Type
Antenna
Application
Manufacturer
Manufacturer
Part Number
Honeywell
Part Number
Beam
Width
Peak
Gain
(dBi)
Freq.
(GHz)
Agency
Compliance
Notes
Omni
(integral)
Point to
Multi-Point
CENTURION MAF94152
50016185-
001
Omni -2
1
2.4 _ _ _
Omni
(integral)
Point to
Multi-Point
L-COM
WHON511 –
0001
50029933-
001
Omni 4 2.4 _ _ _
Omni
3
(remote)
Point to
Multi-Point
L-COM HGV-2409U
50018414-
001
Omni 8 2.4 See Note 3
Directional
3
(remote)
Point to
Multi-Point
L-COM HG2414D
50018415-
001
25° 14 2.4 See Note 3
Sectional
2
(remote)
Point to
Multi-Point
L-COM
HG2414SP-
120
N/A 120° 14 2.4 See Note 2
Notes for Table 6-1
1. The Centurion antenna listed in Table
6-1 has a specified gain of 2.2 dBi. Through EIRP measurements
performed during antenna qualification testing, this antenna when installed in the Honeywell Radome and
attached to the XYR 6000 Transmitter body in either the right-angle or straight integral antenna options
has an actual gain of -2 dBi. This value is used in determining the maximum EIRP for Agency
Compliance purposes.
2. The L-COM Sectional antenna HG2414SP-120 listed in Table
6-1 is approved for use only in Japan. It is
not approved for other locations. This antenna is not available through Honeywell and must be purchased
directly from L-COM.
3. Anatel for Brazil does not allow the use of antenna gains greater than 6 dBi.
See Figure 6-1
and Figure 6-2 for antenna size information.