Honeywell oneWireless XYR 6000 - Page 3

iii OneWireless XYR 6000 Transmitter Professional Installation Guide Revision 3
September 2012
About This Document
This document outlines professional installation requirements for the Honeywell XYR 6000 Transmitter
for the Honeywell OneWireless Network. Professional installation is required to comply with certification
agency and legal requirements. This document must be adhered to for all installations of the Honeywell
OneWireless XYR 6000 Transmitters.
Honeywell does not recommend using devices for critical control where there is a single point of failure or where
single points of failure result in unsafe conditions. OneWireless is targeted at open loop control, supervisory
control, and controls that do not have environmental or safety consequences. As with any process control solution,
the end-user must weigh the risks and benefits to determine if the products used are the right match for the
application based on security, safety, and performance. Additionally, it is up to the end-user to ensure that the
control strategy sheds to a safe operating condition if any crucial segment of the control solution fails.
Revision Information
Document Name
OneWireless XYR 6000 Transmitter Professional Installation
Guide
Document ID
34-XY-25-47
Revision Number
Publication Date
New Revision 1 January 2011
ANATEL and INMETRO certificates added Revision 2 January 2012
Korea certificate added, adjusted TX power settings for
Australia
Revision 3 September 2012
References
The following list identifies all documents that may be sources of reference for material discussed in this publication.
Document Title
XYR 6000 Transmitters Quick Start Guide 34-XY-25-21
Getting Started with Honeywell OneWireless Solutions
OW-CDX010