Honeywell PERFORMANCE LITE 2MP SD User Manual

3
3. Modify the IP address. The default IP address of this camera is 192.168.226.201. Click the information of the camera listed
in the above table to show the network information on the right hand. Modify the IP address and gateway of the camera and
make sure its network address is in the same local network segment as the computer’s. Please modify the IP address of your
device according to the practical situation.
For example, the IP address of your computer is 192.168.1.4. So the IP address of the camera shall be changed to 192.168.1.X.
After modification, please enter the password of the administrator and click on the “Modify” button to modify the setting.
The default password of the administrator is “123456”.
The default password of the administrator is “123456”.
4. Double click on the IP address and then the system will pop up the IE browser to connect IP-CAM. Then follow directions to
install and run the applicable plug-in.
Enter the username and password to log in.
The system will pop up the above-mentioned textbox to ask you to change the default password. It is strongly recommended to
change the default password for account security. If “Do not show again” is checked, the textbox will not appear next time.
Performance Lite 2MP SD Camera - User Manual | Network Connection

Honeywell PERFORMANCE LITE 2MP SD Specifications

General

Brand	Honeywell
Model	PERFORMANCE LITE 2MP SD
Category	Digital Camera
Language	English