Honeywell PERFORMANCE LITE 2MP SD User Manual

20
Use IP address (take IPv4 for example) -There are two options for IP setup: obtain an IP address automatically by DHCP and
use the following IP address. Please choose one of the options as needed.
Click “IP Change Notification Config” to go to the interface as shown below.
Trigger Email: When the IP address of the device is changed, a new IP address will be sent to the appointed mailbox automatically.
PPPoE Settings: Click the “PPPoE Config” tab to go to the interface as shown below. Enable PPPoE and then enter the user
name and password from your ISP.
Port
Go to Config > Network > Port. HTTP port, Data port and RTSP port can be set.
HTTP Port: The default HTTP port is 80. It can be changed to any port which is not occupied.
HTTPs Port: Optional. The default HTTP port is 443. It can be changed to any port which is not occupied.
Data Port: The default data port is 9008. It can be changed to any port which is not occupied.
RTSP Port: The default port is 554. It can be changed to any port which is not occupied.
Performance Lite 2MP SD Camera - User Manual | Configuration

Honeywell PERFORMANCE LITE 2MP SD Specifications

General

Brand	Honeywell
Model	PERFORMANCE LITE 2MP SD
Category	Digital Camera
Language	English