Honeywell PERFORMANCE LITE 2MP SD User Manual

4
or
IPC Computer
Network Cable
Directly Access through IE
The default network settings are as shown below:
IP Address: 192.168.226.201
Subnet Mask: 255.255.255.0
Gateway: 192.168.226.1
HTTP: 80
Data Port: 9008
Use the above default settings when logging in the camera for the first time. Directly connect the camera to the computer
through network cable.
1. Manually set the IP address of the PC and the network segment should be same as the default settings of the IP camera.
Open the network and share centre. Click “Local Area Connection” to pop up the following window.
Select “Properties” and then select internet protocol according to the actual situation (for example: IPv4). Next, click “Properties”
button to set the network of the PC.
Performance Lite 2MP SD Camera - User Manual | Network Connection

Honeywell PERFORMANCE LITE 2MP SD Specifications

General

Brand	Honeywell
Model	PERFORMANCE LITE 2MP SD
Category	Digital Camera
Language	English