Honeywell PX45 - Printer Options and Accessories

PX45 and PX65 High Performance Printer User Guide 9
Printer Options and Accessories
Options are either installed at the factory or by factory service technicians in the
field. Accessories are designed to be installed by the customer. Options and acces-
sories are sold separately.
Option/Accessory Description
Liner/Batch Takeup This factory-installed option separates labels
from the liner and windsup the spent liner inside
the printer’s media compartment.
Paper Cutter Use the paper cutter to cut through continuous
non-adhesive paper-based media or the liner
between labels.
If you are running Fingerprint or Direct Protocol,
you can control the paper cutter using the
commands CUT, CUT ON, and CUT OFF.
Media Roll Retainer Use the media roll retainer with a rotating media
supply hub to keep large media rolls in place.
76 mm (3-in)
Adapter
Use the 76 mm (3-in) adapter with a rotating
media supply hub to use media rolls with 76 mm
(3-in) inner diameter cores.
The adapter cannot be used with a media supply
roll post.
Internal Fanfold
Guides
Use the internal fanfold guides to facilitate
loading media from an external supply.
The internal fanfold guide cannot be used in peel-
off (self-strip) mode or with the label slack
absorber.
.
Label Taken Sensor The label taken sensor (LTS) is a photoelectric
sensor that enables the printer’s firmware to
detect if the last printed label, ticket, tag, etc. has
been removed before printing another copy.
The LTS cannot be used with a paper cutter.
Interface Boards A number of interface boards are available for use
with the printer.
The interface boards are either installed at the
factory or can easily be installed by an Intermec
authorized service technician.
The printer can accommodate these interface
boards:
-802.11 Radio Interface Board
-Parallel Interface Board (IEEE 1284)
-Double Serial Interface Board
-Serial/Industrial Interface Board
-RFID Interface Board
-Applicator Interface Board