98 PX45 and PX65 High Performance Printer User Guide
Ethernet
To view these settings:
• From the printer Main Menu, select Settings > Communications > Ethernet.
• From the printer web page, click the Configure tab. Go to Communications >
Ethernet.
Wireless 802.11
To view these settings:
• From the printer Main Menu, select Settings > Communications > Wireless
802.11.
• From the printer web page, click Configure > Communications > Wireless
802.11
.
Ethernet Setting Description Default
(IPv4) IP Assignment
Method
Specifies how the printer obtains an IP address. DHCP
(IPv4) IP Address Specifies the unique network-level address that is
assigned to each device in a TCP/IP network (IPv4).
0.0.0.0
Subnet Mask Specifies a number that defines the range of IP addresses
that can be used in a TCP/IP network.
0.0.0.0
Default Router Specifies the IP address of a router that is used when a
device sends a packet to another subnet or to an
unknown destination.
0.0.0.0
DHCP Response Specifies if the printer receives DHCP responses by
broadcast or unicast.
Broadcast
(IPv6) IP Assignment
Method
Specifies how the printer obtains an IP address (for IPv6
networks).
Automatic
(IPv6) IP Address Specifies the unique network-level address that is
assigned to each device in a TCP/IP network (IPv6).
Automatic
802.11 Wireless
Setting
Description Default
General
Band Sets the frequency Band for 802.11 2.4GHz
Network Name
(SSID)
Defines the wireless network. To communicate, all access
points and wireless devices must have the same network
name, which is case-sensitive.
Network Type Selects the radio behavior of the printer. Infrastructure
Roaming Controls the roaming inclination of the printer. The
higher the level, the less inclined the printer is to switch
access points. Based on the printer RSSI (received signal
strength)
Off
To Next Page
Loading...
