Honeywell RMA801 - Figure 10: Remote Indicator Connected on the Positive Side of Loop (Analog Mode); Figure 11: Remote Indicator Connected on the Negative Side of Loop (de Mode)

11 RMA803 Remote Indicator User's Guide Revision 2
Figure 10: Remote Indicator connected on the positive side of loop (analog mode)
Figure 11: Remote Indicator connected on the negative side of loop (DE mode)
Note – The resistor “R” indicates the loop resistor which is needed for HART and DE communication
and is typically provided by the user or control system.
ATTENTION
Wiring must comply with local codes, regulations and ordinances. Grounding
may be required to meet various approval body certifications, for example CE
conformity. Refer to Appendix A of this document for details.