15 RMA803 Remote Indicator User's Guide Revision 2
Operation
4.1 Overview
This section provides the information and processes involved for Remote Indicator operation using DE
host and the 2-buttons on the front of the display.
4.2 Configuration using SCT or MCT Toolkit for DE Models
The SCT or MCT Toolkit can be connected across the loop terminals of transmitter. After power is
applied on the loop, perform the upload database in SCT/MCT Toolkit then RMA parameters will be
auto-configured. For every configuration change in the transmitter, it is recommended to perform the
database upload to reflect te changes in RMA801.
Figure 14: RMA HANDHELD WIRING – DE MODE (Analog/Digital)
NOTE:
Any configuration change made in STT700 / STT250 DE device will require upload database operation
from host to configure the RMA. This is applicable for analog and digital mode.
CAUTION
Two hosts should not be connected to DE device. DE device
does not support dual master
To Next Page
Loading...
