33 RMA803 Remote Indicator User's Guide Revision 2
Troubleshooting
7.1 Overview
This section contains information to help you identify the faults in devices and the recommended
actions to correct them. Troubleshooting is performed to determine the cause of the fault by analyzing
the device indications or diagnostics messages. If you require assistance, contact your distributor or
Honeywell Technical Support.
7.2 Critical Diagnostics Screens
When a critical diagnostic is present in the remote indicator, the Standard Display will display the
message as BAD-Tx or BAD-RMA on the bottom line of the LCD. A description of the diagnostic
conditions is given Table 9, along with suggested actions for resolving the problem.
Critical Diagnostics
Figure 18: Local Display Fault Diagnostic Conditions
To Next Page
Loading...
