Honeywell Sensepoint XCD RFD - Page 40

Sensepoint XCD RFD Technical Manual SPXCDHMRFEN Issue 4_08-2016
40
Relay Operation
Congure relay on delay time, relay off
delay time and latch/non-latch
Set Location
Set location (or TAG number)
Set Temperature Unit
Change temperature display unit.
°C (Celsius) or °F (Fahrenheit)
Check Alarm functions
Simulate alarm situation to check the alarm
system without gas present at the sensor
Set ID
Change Modbus
®
slave ID, baud and parity
bit setting (Modbus
®
version only)
Quit
Return to Monitoring mode
Table 11: Transmitter menu descriptions