Honeywell SPM - Default Chapter; Table of Contents

SPM Single Point Monitor
SPM Technical Handbook
TOC-1
Table of Contents
1 Operation
1.1 Introduction ............................................................................................................ 1-2
1.2 Master SPM Illustration ......................................................................................... 1-2
1.3 Before You Begin .................................................................................................... 1-2
1.4 Switching Instrument On and Off ......................................................................... 1-2
1.5 Loading the Chemcassette
®
Detection Tape ........................................................ 1-3
1.6 Monitoring .............................................................................................................. 1-3
1.7 Simulating Gas Conditions ................................................................................... 1-3
1.7.1 Alarm Relays ................................................................................................... 1-3
1.7.2 Gross Alarm Simulation .................................................................................. 1-3
1.7.3 Full Alarm Simulation ...................................................................................... 1-4
1.7.4 Alarm Simulation Key Entries .......................................................................... 1-4
1.7.5 Alarm Simulation Reporting ............................................................................ 1-4
1.8 Verifying System Response .................................................................................. 1-5
1.8.1 Improper System Response............................................................................ 1-5
1.8.2 Open Tape Load Lever Fault ........................................................................... 1-5
1.9 Gas Concentration Conditions ............................................................................. 1-6
1.9.1 Gas Condition Reporting ................................................................................. 1-6
1.10 Instrument Fault Condition ................................................................................. 1-6
1.11 Disabling the External Alarm Relay Contact ..................................................... 1-6
2 Installation
2.1 Wall Mounting ......................................................................................................... 2-2
2.2 Connecting the Power Cord .................................................................................. 2-2
2.3 Connecting Sample and Exhaust Lines ............................................................... 2-3
2.3.1 Sample Line .................................................................................................... 2-3
2.3.2 Particulate Filter .............................................................................................. 2-3
2.3.3 Acid Scrubbing Filters ..................................................................................... 2-3
2.3.4 Hydrogen Sulfide (H
2
S) Scrubber Filter .......................................................... 2-4