Honeywell ST 800 - Table 2 - Conduit Adapters; Figure 9: Electronic Housing Conduit Entries

SmartLine Pressure Transmitter
12 Quick Start Installation Guide December 2016
Table 2 - Conduit Adapters
Step
Action
1
Remove the protective plastic cap from the threaded conduit entry.
2
To ensure the environmental ingress rating on tapered threads (NPT),
a non-hardening thread sealant may be used.
3
Thread the appropriate size adapter (M20 or ½ NPT) into the conduit
entry opening
4
Tighten adapters according to the following table.
Description
Tool
Torque
½ to ¾ NPT Adapter
1 ¼” Wrench
32Nm
24Lb-ft
Figure 9: Electronic Housing Conduit Entries
Note. No plugs come installed in the housings. All housings come with temporary
plastic dust protectors (red) installed and are not certified for use in any installation