Honeywell ST 800 - Configuration Guide; Table 5 - Basic Display Configuration (ST 700 Std;St800 Only)

SmartLine Pressure Transmitter
20 Quick Start Installation Guide December 2016
CONFIGURATION GUIDE
The SmartLine Pressure transmitters has 3 display options:
 Basic LED Display: 2 lines, 16 characters (ST 700 Std/800 only) - Table 5
 Advanced LED Display: Multi-line display (ST 800 only) - Table 6
 Simple LED Display: 2 lines, 6 character (ST 700 Std only) - Table 7
Table 5 – Basic Display Configuration (ST 700Std/ST800 only)
Parameter Applicability
Locally
Writable
LCD Contrast Always Yes
Rotation Time FF Only Yes
PV Display HART/DE Yes
PV Decimals HART/DE Yes
Pressure Units HART/DE Yes
Range/Cal Units FF Only Yes
Zero Correct Always Yes
LRV Correct HART/DE Yes
URV Correct HART/DE Yes
Reset Corrects HART/DE Yes
DAC Zero Trim HART/DE Yes
DAC Span Trim HART/DE Yes
Loop Test HART/DE Yes
LRV Always HART/DE
URV Always HART/DE
Damping Always HART/DE
NAMUR HART/DE Yes
Filter Perf HART only Yes
Transfer Func HART/DE DP Only Yes
Flow Cutoff HART/DE DP Only Yes
Flow Breakpoint HART/DE DP Only Yes
Tag ID HART/DE Yes
Install Date HART/FF HART Only
Firmware Always No
Protocol Always No
Model Key Always No
Exit Menu Always n/a