SmartLine Pressure Transmitter
December 2016 Quick Start Installation Guide 9
Flush Mounting
To mount a flush mounted transmitter model, cut a hole for a 1-inch standard pipe in
the tank or pipe where the transmitter is to be mounted. See Figure 7
Weld the 1-inch mounting sleeve to the wall of the tank or to the hole cut on the pipe.
Insert the meter body of the transmitter into the mounting sleeve and secure with the
locking bolt. Tighten the bolt to a torque of 6.4Nm ±0.30Nm [4.7ft.-lbs. ±0.2ft.-lbs.]
Once the transmitter is mounted, the transmitter housing can be rotated to the desired
position. See Figure 7.
Figure 7: Flush Mounting
To Next Page
Loading...
