VisionPRO TM 8000 Touchscreen Programmable Thermostat
C7189 A
W
A POWER SUPPLY PROVIDE DISCONNECT MEANS AND
OVERLOAD PROTECTION AS REQUIRED
A IF MORE TIIAN ONE C7189 REMOTE SENSOR IS REQUIRED,
REFER TO FIGURE 3
A WIRES MUST HAVE A CABLE SEPARATE FROM THE
THERMOSTAT CABLE M19972
Fig. 28. Wiring a single C7189 Indoor Sensor.
A, A
07189 07189
Y2
_I_2 A
A,
82 07189 07189 07189
C7189 C7189 C7189
C7189 C7189 C7189
A SENSORS MUST BE ARRANGED IN THIS
CONFIGURATION TO OPERATE CORRECTLY.
A WIRES MUST HAVE ACABLE SEPARATE FROM THE
THERMOSTAT CABLE. M19973
Set Calendar and Time
Thermostat keeps current time and day for up to ten years
under normal use after the calendar is set.
When the thermostat is first powered, the display is ready to
set the calendar and time.
NOTE: Calendar can also be set in the Installer Setup.
1. Press the arrow keys to set the year, month and day.
2. Press the Done key.
SET CURRENT DAY_
SET MONTH _ _,. B
/I ,c,4/
SE ARROWS TO SET YEAR AND TIME
M22424
3. Press the arrow keys to set the current time.
4. Press the Done Key.
M22425
Fig. 29. Wiring Multiple C7189 Sensors.
68-0280 14
To Next Page
Loading...
